C0 General Purpose Tile Adhesive 20kg

Universal Tile Adhesive. A single-component, polymer-modified cementitious adhesive. Ready to use with water.

Features:

  • Flexible / Thermal resistance

  • Hollowing & peeling resistance

  • Thin-layer / Time-saving

  • Strong bond / Water resistant

Category:

Indoor public and wet areas (floors & walls).

Floor: 600 x 600 mm

Glazed Wall: 300 x 600 mm

General: 300 x 600 mm

Substrate: Must be firm, flat, and clean.

Mixing: 20kg powder to ~5kg water (adjust as needed).

Stirring: Pour water, add powder, and mix until smooth. Let stand for minutes, stir briefly, and use.

Application: Apply with notched trowel (~1m² per area). Press and adjust tiles (use spacers for alignment).

Finishing: Clean and grout 24 hours after floor tiling.

Standards Compliance Complies with GB/T 25181-2019 “Ready-mixed Mortar” technical requirements.

Test ItemsStrength (Mpa)TS (Indoor I) II Type
Initial AdhesionStrength≥ 0.5
Water ResistanceStrength≥ 0.5
Heat ResistanceStrength≥ 0.5
Freeze-ThawStrength—
Open Time (OT 20Min)Strength≥ 0.5

NOTE

  • Substrate: Must be firm, flat, and clean.
  • Mixing: 20kg powder to ~5kg water (adjust as needed).
  • Stirring: Add powder to water. Mix until a smooth, lump-free paste forms. Let stand for minutes, stir briefly, and use.
  • Application: Apply with notched trowel (~1m^2 per area). Press and adjust tiles (spacers recommended). Clean and grout 24 hours after floor tiling.

It is a single-component, polymer-modified cementitious adhesive for indoor public and wet areas, suitable for both floors and walls.

It is flexible with good thermal resistance, resists hollowing and peeling, allows thin-layer, time-saving application, and provides a strong, water-resistant bond.

It supports floor tiles up to 600 x 600 mm, glazed wall tiles up to 300 x 600 mm, and general tiles up to 300 x 600 mm.

The substrate must be firm, flat, and clean before the adhesive is applied.

Mix approximately 20kg of powder with about 5kg of water, adjusting slightly as needed for workability.

Apply with a notched trowel (approx. 1m² per batch) and lay tiles within the 20-minute open time, pressing and adjusting them with spacers for alignment. Grout 24 hours after floor tiling.

It complies with the technical requirements of GB/T 25181-2019 “Ready-mixed Mortar.”

Yes, we accept bulk wholesale orders and can arrange OEM/private-label packaging. Please contact us for pricing based on order volume.

Related products